Parts / Offset gear drive: pinion
Drag to orbit · pinch / scroll to zoom · two fingers / right-drag to pan. Shown as exported for printing, on a 10 mm grid.
Offset gear drive: pinion fallback
Pinion on the motor shaft.
- File
hardware/stl/offset_gear_pinion.stl- Bounding box
- 17.59 × 17.59 × 6.00 mm (X × Y × Z, as exported; Z up from the bed)
- Volume
- 1.13 cm³; ≈ 1.4 g if printed solid in PETG (real mass depends on walls and infill)
- Mesh
- 1,960 triangles
- Material
- PETG
- Layer
- 0.12 mm
- Walls / infill
- 100 %
- Orientation
- Flat.
- Supports / brim
- None.
- Quantity
- -
- Versions
- ABCD
Print settings are starting points from ASSEMBLY.md and the print plan, not values tested on this design. Dimensions that depend on the knob, rod or clip are estimated from photo, not caliper.
← Offset gear drive: ring gearOffset gear drive: cover base →