Parts / Offset gear drive: cover base
Drag to orbit · pinch / scroll to zoom · two fingers / right-drag to pan. Shown as exported for printing, on a 10 mm grid.
Offset gear drive: cover base fallback
Round 5 split the old one-piece cover (which could not be assembled) into base + lid. Not yet re-checked by the print plan.
- File
hardware/stl/offset_gear_cover_base.stl- Bounding box
- 46.40 × 30.40 × 9.40 mm (X × Y × Z, as exported; Z up from the bed)
- Volume
- 2.73 cm³; ≈ 3.5 g if printed solid in PETG (real mass depends on walls and infill)
- Mesh
- 6,044 triangles
- Material
- PETG
- Layer
- 0.2 mm
- Walls / infill
- 3 walls
- Orientation
- Tray, open side up.
- Supports / brim
- None expected.
- Quantity
- -
- Versions
- ABCD
Print settings are starting points from ASSEMBLY.md and the print plan, not values tested on this design. Dimensions that depend on the knob, rod or clip are estimated from photo, not caliper.