Parts / Housing lid (collar)
Drag to orbit · pinch / scroll to zoom · two fingers / right-drag to pan. Shown as exported for printing, on a 10 mm grid.
Housing lid (collar) primary
S-blended collar that hugs the rotating cup with a 0.4 mm gap so lift cords cannot catch. Carries the small key that slides into the clip rail's fork.
- File
hardware/stl/housing_slim_lid.stl- Bounding box
- 40.06 × 31.94 × 36.40 mm (X × Y × Z, as exported; Z up from the bed)
- Volume
- 10.38 cm³; ≈ 13.2 g if printed solid in PETG (real mass depends on walls and infill)
- Mesh
- 22,652 triangles
- Material
- PETG or ASA
- Layer
- 0.12-0.16 mm
- Walls / infill
- 3 walls, 15 %
- Orientation
- Collar up, spigot down.
- Supports / brim
- On the build plate only: under the spigot ledge and the hidden inner ceiling; block supports on the outer S-surface.
- Quantity
- 1 per head
- Versions
- ABCD
Print settings are starting points from ASSEMBLY.md and the print plan, not values tested on this design. Dimensions that depend on the knob, rod or clip are estimated from photo, not caliper.