Parts / Housing base
Drag to orbit · pinch / scroll to zoom · two fingers / right-drag to pan. Shown as exported for printing, on a 10 mm grid.
Housing base primary
Rounded pebble that holds the 28BYJ-48 with its ears snipped; flat back rests on the frame face. Round 5 fixed the bottom slit and the thin wire-box corners the print plan flagged; no tail socket any more.
- File
hardware/stl/housing_slim_base.stl- Bounding box
- 40.07 × 31.95 × 21.10 mm (X × Y × Z, as exported; Z up from the bed)
- Volume
- 8.35 cm³; ≈ 10.6 g if printed solid in PETG (real mass depends on walls and infill)
- Mesh
- 8,448 triangles
- Material
- PETG or ASA (UV / heat near the glass)
- Layer
- 0.16 mm
- Walls / infill
- 3 walls, 20 %
- Orientation
- Bottom down (flat underside on the bed).
- Supports / brim
- None. Elephant-foot compensation about 0.15 mm.
- Quantity
- 1 per head
- Versions
- ABCD
Print settings are starting points from ASSEMBLY.md and the print plan, not values tested on this design. Dimensions that depend on the knob, rod or clip are estimated from photo, not caliper.