Parts / Pane pack, panel only (recommended)
Drag to orbit · pinch / scroll to zoom · two fingers / right-drag to pan. Shown as exported for printing, on a 10 mm grid.
Pane pack, panel only (recommended) primary
Flat frame for the 12 V 1.5 W 115 x 85 x 3 mm panel, standing between the panes. The LiPo stays in the room-side box (better at -20 C). Mounting between the panes is not designed yet; the pad-wire position is an assumption.
- File
hardware/stl/pane_pack_panel_only.stl- Bounding box
- 87.80 × 117.80 × 4.10 mm (X × Y × Z, as exported; Z up from the bed)
- Volume
- 7.40 cm³; ≈ 7.9 g if printed solid in ASA (real mass depends on walls and infill)
- Mesh
- 5,656 triangles
- Material
- ASA (or PETG)
- Layer
- 0.2 mm
- Walls / infill
- 3 walls, 100 %
- Orientation
- As exported: back down, snap hooks on top.
- Supports / brim
- None.
- Quantity
- 1 per panel
- Versions
- C
Print settings are starting points from ASSEMBLY.md and the print plan, not values tested on this design. Dimensions that depend on the knob, rod or clip are estimated from photo, not caliper.
← Controller box lid, version DCombined pane pack, version D (panel + low-temperature cell) →