Parts / Cable clip
Drag to orbit · pinch / scroll to zoom · two fingers / right-drag to pan. Shown as exported for printing, on a 10 mm grid.
Cable clip primary
Small white clip that guides the 6-wire flat cable along the frame. Not in the round-4 print plan (new in round 5).
- File
hardware/stl/cable_clip.stl- Bounding box
- 8.00 × 9.60 × 4.50 mm (X × Y × Z, as exported; Z up from the bed)
- Volume
- 0.12 cm³; ≈ 0.2 g if printed solid in PETG (real mass depends on walls and infill)
- Mesh
- 4,068 triangles
- Material
- PETG
- Layer
- 0.2 mm
- Walls / infill
- 100 %
- Orientation
- Flat side down.
- Supports / brim
- None.
- Quantity
- about 10 for 2 windows / 6 for 1 (est.)
- Versions
- ABCD
Print settings are starting points from ASSEMBLY.md and the print plan, not values tested on this design. Dimensions that depend on the knob, rod or clip are estimated from photo, not caliper.
← Pane pack cell cover (legacy)Offset gear drive: ring gear →