Parts / Anti-rotation clip latch (piece 2 of 2)
Drag to orbit · pinch / scroll to zoom · two fingers / right-drag to pan. Shown as exported for printing, on a 10 mm grid.
Anti-rotation clip latch (piece 2 of 2) primary
Front half of the hood. Pushed straight onto the rod guide clip from the room side after the clip rail: its tongue clicks onto the other tab wing and two split-arrow snap tongues click into the clip rail behind the rod, so the two pieces enclose the rod without touching it. No screws or glue. Removal: pull it straight off toward the room, then slide the clip rail sideways.
- File
hardware/stl/anti_rotation_arm_clip_latch.stl- Bounding box
- 24.10 × 21.90 × 14.20 mm (X × Y × Z, as exported; Z up from the bed)
- Volume
- 1.55 cm³; ≈ 2.0 g if printed solid in PETG (real mass depends on walls and infill)
- Mesh
- 2,568 triangles
- Material
- PETG
- Layer
- 0.16-0.2 mm
- Walls / infill
- 4 perimeters, 100 %
- Orientation
- As exported: left outside face on the bed (the snap prongs and the side tongue then flex in the layer plane).
- Supports / brim
- None.
- Quantity
- 1 per head
- Versions
- ABCD
Print settings are starting points from ASSEMBLY.md and the print plan, not values tested on this design. Dimensions that depend on the knob, rod or clip are estimated from photo, not caliper.
← Anti-rotation clip rail (piece 1 of 2)Controller box base, version A (USB-C) →